I actually changed topside panel = no helps, I cleaned circuit board and all of wires by contact spray = no helps. AUX still working and GFCI too, but i everytime i must reboot my SPA on breaker. There is no error code, just flashing, blinking and turn off heater, turn off all of pumps. Everything works fine until i end my 20 minute session and then i click any button on topside all this screen gonna blinking like crazy. I have no more ideas whats wrong with my spa. I have HydroQuip CS6230 hot tub with Gecko topside, There is often a problem with blinking Topside like crazy and clicking red dot on circuit board. If you're from the UK I may be able to help regarding parts etc. Unless you have service/gate valves you will have to drain the hot tub, unscrew the unions and check inside the heater for debris within the heater assembly. Ensure that there are no blockages within the heater. If they aren't the same you'll probably have to replace them. If you have a multimeter you could also check the resistance of the two sensors. Follow the wiring from the sensor to the plug(s) on the PCB and check that the connections are good, they have a habit of devekoping a poor connection. 'Sn' is a general error message relating to the temperature sensors.Īssuming that you have a Balboa spa pack (M7 version), turn off the power and remove the spa pack cover, you'll find two temperature sensors mounted in the top of the heater tube one at each end.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |